The WindHog 650 series turbine is rated at 200 kwh of production a month in a
10mph average wind speed.
This unit is available in 12, and 24 volt systems. 48 volts with two
turbines is Available.
Note due to high demand this item will take 30 days to construct for you.
It utilizes High Speed Aluminum Blades Seen Right.
Blades are 35" long with a 14" T1 hardened steel hub. Fasteners are included.
Startup for is 7.6mph
You will rarely see this unit not spinning even in 2-3mph of wind.
All New Permanent Magnet alternator for efficient power with all new 10 times
larger stator than any competitor model.
No electronics in alternator
3 Phase output allows power to get to controller more efficiently with less
expensive wire
Stainless slip ring stops wires from being twisted when turbine pivots.
1-15/16" cast iron greaseable bearing for mounting.
Fits 1.5" schedule 80 black pipe.
All steel no plastic all welded design
Stainless Sealed Alternator Bearings.
Survival 90mph
Breaking system: Electronic
Unit weight is 80lbs
Controller included.
View the Wiring Diagram
here:
View the Manual Here:
Manual
$1500.00 with 1 year warranty
$1800.00 with 5 year warranty
Find a dealer near you!
